Bathroom Hardware Supervision Hardware Installation

We all know that the installation of Hardware and sanitary ware in home furnishings is the key, so we are more concerned about how to install hardware wares? For the installation of hardware must be careful, otherwise dismantling is a major project, this time we must seriously understand the following knowledge, but also to understand is how to supervise the installation of hardware and sanitary ware? Know that this can only be overseen at the time of installation. Check out the information below.

How to supervise the installation of hardware ware

1. When installing, determine the location of the water pipes and wires according to the water route and circuit diagram. Be sure to avoid the water pipes and wires to prevent breaking the water pipes and breaking the wires.

2. When installing on the surface of the tile, first use the glass drill to break the tile, or use a steel nail or hammer to knock the tile to break through the tile, and then use an electric hammer to beat the air to avoid breaking the tile.

3, the installation tool can not directly touch the hardware, apply a clean soft cloth wrapped and tightened.

4, a variety of mixer or mixer, try to install a stainless steel cover.

5, pay attention to the installation of shower room, bathtub, to determine whether to reserve power.

6. When installing the toilet, do not fill the concrete below to prevent the toilet from bursting. Apply the matching cement, and then place the glass glue on the outside.

The above is the introduction of the methods for supervising the installation of hardware and sanitary ware brought by Xiao Bian. I hope to help everyone. For more information, please stay tuned.

<\p><\div>